Hey guys I'm new here,
I have a P-07 Gen 2 w/ decocker about 6 months now ,
I have put in from CGW an 18 # hammer spring, reduced power firing pin spring, hardened steel firing pin retaining pin , reduced power block Plunger spring, reduced power trigger spring, I have also through numerous videos and threads , sanded and Polished all internal metal to metal contact points.
Using a Lyman trigger pull gauge I have tested both DA/SA pulls 10 TIMES EACH with an average of
9# 8oz DA and a 2# 12oz SA..
Very smooth action.
I have seen where others have gotten their double action pull down lower than what I have. Question is without replacing the trigger or the hammer is there anything else I can do to reduce the double action pull without reducing the single action any more than it is??
I don't want a race competition pistol !!
This is my EDC defense carry weapon.
Thanks in advance for your replies.
I have a P-07 Gen 2 w/ decocker about 6 months now ,
I have put in from CGW an 18 # hammer spring, reduced power firing pin spring, hardened steel firing pin retaining pin , reduced power block Plunger spring, reduced power trigger spring, I have also through numerous videos and threads , sanded and Polished all internal metal to metal contact points.
Using a Lyman trigger pull gauge I have tested both DA/SA pulls 10 TIMES EACH with an average of
9# 8oz DA and a 2# 12oz SA..
Very smooth action.
I have seen where others have gotten their double action pull down lower than what I have. Question is without replacing the trigger or the hammer is there anything else I can do to reduce the double action pull without reducing the single action any more than it is??
I don't want a race competition pistol !!
This is my EDC defense carry weapon.
Thanks in advance for your replies.
