CZ Firearm Forums : CZTalk banner
1 - 4 of 4 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Picked up a very slightly used Shadow 2 Black and Blue a few weeks ago and while dry firing the right hand side [from the rear , as held to shoot] safety lever popped off the gun.
After looking around at diagrams for the Shadow 2 I took it apart and seen the right hand safety detent was missing. Called the original owner and he swears he has never took the gun apart other than field stripping.
So i looked around to find one in stock and every time I came to a "does this part fit my model" it says no. So does the Shadow 2 use a safety detent on the left[with a spring] and on the right [without a spring] or is there another issue I'm missing? The safety detent is item number 15 on the attached imagine.
Font Line Parallel Engineering Auto part
Font Line Parallel Engineering Auto part
 

·
Registered
Joined
·
138 Posts
I replaced the safety on mine with the extended one but the right side stayed on I just had to pull back the spring of the left side to pull the safety out and put the new one in with the hammer pulled all the way back.
 

·
Registered
Joined
·
2 Posts
Discussion Starter · #3 ·
I replaced the safety on mine with the extended one but the right side stayed on I just had to pull back the spring of the left side to pull the safety out and put the new one in with the hammer pulled all the way back.
That's because your right side safety detent is still in place. Mine has poof disappeared.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top