CZ Firearm Forums : CZTalk banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Looking to get my P01 and My SP01 Tactical both Slides cut for RMR and front reductions more for speed cuts and help possible muzzle flip than for looks even though I think it does look good.

I am not looking to do this if I am not going to gain any improvements for performance, so I need some feedback from you all if you have had any of your CZ 75 platforms slide cut with front cuts and if so who did the work (I am looking to have CGW do mine since I have had them do all my Performance packing on all my CZ's), and what are your thoughts on what you had done, do you like it, was it worth the cost and would you do it again, and if not why or what would you do differently?

Thanks.
 

·
Registered
Joined
·
12 Posts
Looking to get my P01 and My SP01 Tactical both Slides cut for RMR and front reductions more for speed cuts and help possible muzzle flip than for looks even though I think it does look good.

I am not looking to do this if I am not going to gain any improvements for performance, so I need some feedback from you all if you have had any of your CZ 75 platforms slide cut with front cuts and if so who did the work (I am looking to have CGW do mine since I have had them do all my Performance packing on all my CZ's), and what are your thoughts on what you had done, do you like it, was it worth the cost and would you do it again, and if not why or what would you do differently?

Thanks.
I would recommend you send them to CZ Custom for their optic plate system installation. That way you are not tied to one particular optic installation footprint, even if you're sure (like me) that Trijicon is all you'll use.

You never know what new optics will come out in the future that might displace Trijicon as king of the hill.

As far as slide lightening cuts, not a fan. I rather change the recoil spring to get the pistol to shoot flatter with less muzzle dip when the slide closes.
 
1 - 2 of 2 Posts
Top